I found this purely by chance, while searching for a synth "diy". Although I knew that the RASPI had the potential to do big stuff, the originator of this project deserves all the Kudos folks can give him,
Now as I scroll through(as a complete samplerbox newbie) there are 2 things I see.
1) The initial development was on the RASPI 2
2) there is a MUCH bigger difference between V2 and V3b+
So as I have been working my way through the posts, but not all of them, I'd like to ask a "general consensus" question:
"Should I start with a V2, build the box get it working and go from there, or is there a set of step by step "How To's" for one of the V3's that someone could direct me to?
Although I am not new to Linux or DIY (my 1st install came on 27 floppies) I have found that sometimes it is best to start something new on a premise where "everything works" and then branch off from there.
Any and all info is greatly appreciated. this is a VERY exciting project.
Thanks to the Original DEV and any and all that can help me out.